Ron Guest

Follow @ronguest on

My adventure in using flex filament continued today. I found this simple model for holding 1/4” screwdriver bits:

This is a great use of a flex filament because the holes are small enough to snugly hold the bits and at the same time the flex makes them easy to remove.

My previous 3D benchy didn't want to release from the satin PEI sheet so I used textured for this print. It lost adhesion at about 4mm height so I added a brim which worked well.

← An IndieWeb Webring πŸ•ΈπŸ’ β†’